15
8
Pairing the Wireless Siren/Remote Control
1.
Press and hold the pair button on the wireless siren (see page 5 - Fig.
3). After a short moment you will see a solid blue LED. The DVR will
detect the siren and add it to the sensor list. Put the cover back on after
pairing and fasten all three screws.
2.
The battery for the remote control is pre-installed so there is no need
to open the battery cover located at the rear.
3.
Press one of the buttons on the remote control. The DVR will detect
the remote control and add it to the sensor list. Repeat this step if you
have more than one remote control.
4.
Click “End Pair” then click “Apply”.
Group
- The remote control is always set to “SOS” and cannot be
changed.
Don’t forget to click “Apply” otherwise any changes made will not be
saved.
1) Transmit LED
- If you don’t see a red LED
when you press a button, this indicates the
battery is flat.
2) Panic
- Click this to activate the wireless
siren instantly.
3) Alarm On
- Click this to enable all sensors
listed in the sensor list.
4) Alarm Off
- Click this to disable all sensors
listed in the sensor list.
5) Perimeter On
- Click this to enable all win-
dow/door sensors only. This allows movement
inside the house but if a window or door is
opened this will activate the wireless siren.
2
3
4
5
1
