Swann MF-1F, Installation Manual

Page: 5 / 12

2. Slide the metal leg into one of the plastic corner retaining
sockets in the bottom of the laundry tub. All four legs are
identical and can be installed in any one of the four corners.
3. Place a block of scrap wood over the end of the leg and
drive the leg down into the socket with a hammer.
4. Install the other three legs in the same manner.
5. Install one leg leveler on each leg using the screw and nut
included with each unit. Do not completely tighten the
screws until the laundry tub is in its final location and can
be leveled.
1b. Attach Filler Brackets and Wall Mount —
MF-1W and MF-2W (Single and Double Bowl
Models)
1. Place the laundry tub upside down on a flat surface.
Protect the top edges of the laundry tub from scratches or
other damage by placing cardboard or other scratch
resistant material on the floor.
2. Find the right-side filler bracket. Install it with the end of
the filler bracket fitted between the outside of the sink and
guide posts (1). Also place the filler bracket over guide
post (2) and the screw hole in the bottom of the laundry
tub.
3. Using a flat blade screwdriver, install one panhead screw
to hold the filler bracket in place. Do not overtighten the
screw.
4. Install the left-side filler bracket in the same manner.
LT-020
LT-019
2
1
LT-018
LT-004
SCREW
LEG LEVELER
NUT
LT-003
LT-002
LT-001
800-325-7008 5 The Swan Corporation – Swanstone
Installation Procedure
MF-4W (Single Bowl Model)
3. If you have the MF-4W wall mount assembly: Using a flat
blade screwdriver, install one panhead screw and washer
to hold the filler bracket in place. Do not overtighten the
screw.
Slide the metal or plastic leg into one of the plastic corner
retaining sockets in the bottom of the laundry tub. All four
legs are identical and can be installed in any one of the
four corners. 2.