Swann Advantage series, Manual

Page: 16 / 27

— 16 —
Motion Setup
1. User setup video record method by Motion Trigger. Reference 5.7.
MOTION DETECTION SETUP
CHANNEL 1 SENSITIVITY 4
CHANNEL 2 SENSITIVITY 4
CHANNEL 3 SENSITIVITY 4
CHANNEL 4 SENSITIVITY 4
CHANNEL 1 AREA SET
CHANNEL 1 AREA SET
CHANNEL 1 AREA SET
CHANNEL 1 AREA SET
PRESS(UP,DOWN), THEN(SELECT)
PRESS(MENU) TO EXIT
CHANNEL 1- 4 SENSITIVITY:
Press “ Select” to adjust
sensitivity of motion detection.
High (1----------9,OFF) Low
When it’s OFF, the channel cannot
be triggered by movement.
CHANNEL 1- 4 AREA SET:
Press “ Select” to enter area
setting state, the picture of selected
channel is divided into 144(12*12)
blocks, and then press “REW” to
move left, press “FWD” to
move right, press “UP” to move up, press “DOWN” to move down, press “
Select” to set the block to being active or not.
When the block is transparent, it’s active to record.
When the block is covered by shadow, it is not active. NO Recording.
After completing the “MOTION SET”, User can exit MENU, And press
[ Record ] to start Motion Record.
V
DVR Setup
5.16 NTSC/PAL Output Select