SVS-Vistek CameraLink svs11002, User Manual, Page: 6 / 47

Users Manual Area Scan Cameras svs11002 and svs16000 Page 6
2.0 Pinout and Installation
Warning
The CCD camera is built with CMOS-LSI circuits. All internal electronics in the camera are
sensitive to high voltage or electrostatic discharge. The camera can be destroyed if carelessly
handled, so extreme care should be taken during set up and operation.
Do not expose the sensor to a direct laser beam as this could damage the sensor! See Safety
Instructions at Appendix E. Warranty will be void if not followed.
2.1 Unpacking and Installation
- Camera
- Power supply (if ordered/option)
- User Manual
- CD with “Convenient Cam” program
Install the camera in a appropriate, dry place. Use either Tripot or M3 front holes for
mounting. Use good heat sinks to manage power dissipation.
Note that the “U” version has heat sink attached to the housing. To take advantage of
the high frame rate a good airflow is highly recommended. If not done and operated in
high temperature environment image distortions will be observed.
CAMERA CAN BE DESTROYED IF YOU DON’T FOLLOW THESE INSTRICTION AND
WARRANTY WILL BE VOID !
2.2 Power supply
Male connector (Type TB3M micro switch)
PIN 1
+12V to +15 V DC
PIN 2 Reserved (Do not connect)
PIN 3 GND
Current consumption:
svs11000/16000 =1200 mA (typical “S” and “F” version)
1500 mA (“U” version)
Peak current on “Power on” up to 2 Ampere!
2.3 Trigger connector
TB 5M
connector, 5 pin, is used to give an external TTL-trigger-input (min. 5V TTL galvanic
decoupled) to the camera, if it is not done per framegrabber.
TTL Exsync input to trigger camera (optocoupler input)
Pin 4: Tr - (Exsync GND)
Pin 5: Tr + (Exsync TTL)
See outline in chapter
3.4
See chapter 2.6 Available operation modes