Svero Lifting AB | Momarken 19, 556 50 Jönköping, Sweden
T:
+46 (0) 36 31 65 70
2
Manual
Read this manual carefully before using the Smart Hoist. Improper handling can be
dangerous!
Use
The extremely low headroom, light and easy to mount Smart Hoist is intended to be
mounted on a beam to lift and carry a load that can be displaced along the beam and
hoisted up and down. It is especially well suited for cramped spaces.
Description
Svero's Smart Hoist 22 is mostly made of aluminum (side-plates, suspension bolt, holder,
covers and chain hoist casing) and hard impact resistant fiberglass reinforced plastic
(wheels), and is therefore very lightweight.
The design where the lifting function is fully integrated with the horizontal movement,
means that the minimum headroom is very low, and that the load-hook is the lowest
point of the structure, without any other part of it obstructing the possibility to fully utilize
the low headroom.
The Smart Hoist can be adapted for beams with flange widths between 120 and 180 mm.
It is delivered prepared for a 120 mm beam, but by adding spacers (included) it can be
adapted for 140 mm, 160 mm and 180 mm beams. The suspension bolt has a square
cross section and conical holes to fit the stop screws (Pic. 13). Through this design, the
suspension bolt is fixed to the side-plates. Also the holder is fixed with a stop screw at
the center of the suspension bolt, to facilitate the centering of the holder under the beam.
Furthermore, the tread of the wheels is both cylindrical and conical (the outer part), which
make it suitable both for beams with even-thickness flanges (IPE, HEA, HEB) and for
