Suzuki SWIFT RS415 2017, Service Manual

Page: 1134 / 1257

9D-9 Wipers / Washers:
Rear Wiper and Washer Switch Inspection
S4RS0A9406009
Check for continuity between terminals at each switch
position. If check result is not as specified, replace
switch.
Rear Wiper Relay Removal and Installation
S4RS0A9406015
Removal
1) Disconnect negative (–) cable at battery.
2) Remove junction block assembly referring to “BCM
(Included in Junction Block Assembly) Removal and
Installation: in Section 10B”.
3) Remove rear wiper relay.
Installation
Reverse removal procedure for installation.
Rear Wiper Relay Inspection
S4RS0A9406014
1) Check that there is no continuity between terminal
“3” and “4”. If there is continuity, replace relay.
2) Connect battery positive (+) terminal to terminal “2”
of relay.
3) Connect battery negative (–) terminal to terminal “1”
of relay.
4) Check continuity between terminal “3” and “4”. If
there is no continuity when relay is connected to the
battery, replace relay.
Specifications
Tightening Torque Specifications
S4RS0A9407001
NOTE:
The specified tightening torque is also described in the following.
“Wipers and Washers Components: ”
Reference:
For the tightening torque of fastener not specified in this section, refer to “Fasteners Information: in Section 0A”.
Terminal
Position
OFF
INTO
1 2 4 3
WASH
ON
ON + WASH
ON + WASH
INT
ON
WASH
1
2 3 4
I4RS0A940027-
“4”
“2”
“1”
“3”
I4RS0A940028-
Fastening part
Tightening torque
Note
N
˜
m kg-m lb-ft
Washer tank bolt 4 0.4 3.0 )
Windshield wiper bolt 8 0.8 6.0 )
Windshield wiper arm nut 16 1.6 11.5 )
Rear wiper motor mounting bolt 8 0.8 6.0 )
Rear wiper nut 5 0.5 4.0 )
Rear wiper arm nut 8 0.8 6.0 )