1
Be sure to read the operation manual thoroughly before attempting to operate the machine. After
reading, be sure to keep this manual near the machine any time to read again.
To non-observance of the following safety instructions can cause bodily injuries or damage to the
machine.
A) EXPLANATION OF DANGER, CAUTION AND NOTICE
1.Danger :There is a risk of death, serious injuries or damage to the body or machine in case of
miss-operation, maintenance, miss-adjustment or other when in use of machine.
2.Caution :There is a risk of death, serious injuries or damage to the body or machine in case of
miss-operation, maintenance, miss-adjustment or other when in use of machine.
3.Notice
:There is a risk of injuries or damage to the body or machine in case of miss-operation,
maintenance, miss-adjustment or other when in use of machine.
B) EXPLANATION OF INDICATION LABEL
1. Danger, Caution and Notice
2. Injury
3. Electric shock
4. Direction of correct rotation
5. Mark of ground
C) DANGER
To prevent the electric shock, switch off the main switch and pull out the main plug from outlet when
opening motor cover, electronic devices, control box or in case that there is possibility of thunderbolt.
D) CAUTION
・
This machine should be used by the correct voltage, check the machine serial number plate and seal
of the cord plug for it before operating the machine.
・
Never drop or wet the foot switch.
・
The machine should be only started and operated after having read the operation manual very
carefully, and only be according trained persons.
・
This machine should be only used for the purpose intend as industrial sewing machine.
・
All safety devices must be in the original position when the machine is ready for working or when in
use. Using the machine without safety devises is prohibited.
・
For your personal protection, it is recommended that you wear safety glasses.
・
If alterations are made to the machine, all of the machine safety rules must be considered.
Conversions and changes are made at your own risk.
・
Maintenance, repair and conversion works (see item 5) must be only done by trained technicians or
qualified personnel. Only genuine spare parts approved by manufacture should be used for repair.
・
Any work on the electrical equipment must be done by qualified electricians or under direction and
supervision or qualified personnel.
・
Works on live parts and equipment under electrical tension is prohibited. They are only by
trained technicians or qualified personnel.
・
The following operations must not be performed until the machine has been disconnected from the
power supply by switching off the main switch or by pulling out the main plug.
-
Threading needle(s), loopers, spreaders and gimp thread etc.
-
Replacing parts such as needle(s), presser foot/cloth clamp plate, throat plate, needle guard,
loopers, spreaders, feed dog, fabric guide, knife/blade, cutting block and thread trimmer etc.
1 2 3 4 5
