ENGINE
3-11
• After remounting the engine, route the wire harness, cables
and hoses properly. (
!
7-12)
• Tighten the oil drain plug
1
to the specified torque.
"
Oil drain plug: 23 N.m (2.3 kgf.m, 16.5 lb-ft)
• Install the gearshift lever to the gearshift shaft in the correct
position.
'
Gearshift lever height
A
Standard: 55 mm (2.2 in)
• Pour 3.3 L (3.5/2.9 US/Imp qt) of SF or SG classified (API)
engine oil, with a viscosity rating of 10W40 (SAE), into the en-
gine after overhauling it.
• Start up the engine and allow it run for several minutes at idle
speed and then stop the engine. Wait three minutes and then
check that the oil level remains between the marks on the oil
level inspection window.
Oil change
3 300 ml (3.5/2.9 US/Imp qt)
Oil and filter change
3 500 ml (3.7/3.1 US/Imp qt)
Engine overhaul
4 600 ml (4.9/4.0 US/Imp qt)
• Adjust the following items to specification.
*Throttle cable play ...............................................
!
2-11
*Engine idle speed ...............................................
!
2-11
*Carburetor synchronization .................................
!
4-24
*Drive chain ..........................................................
!
2-15
Summary of Contents for GSF1200 2001
