Suzuki DF25 2006, Rigging Manual

Page: 43 / 45

3-28 MOTOR INSTALLATION
MOUNTING TO THE TRANSOM
DF60/70, DF90/115, DF140
Contained parts

Nut
D
: 55 N·m (5.5 kgf-m, 40.0 lb-ft)
NOTE:
• Drill the upper holes center at least 25 mm (1.0 in) away from
the transom top surface.
• Install the large diameter washer
B
on the transom board
side.
• To ensure a water-tight motor installation, sealant (SUZUKI
SILICONE SEAL or equivalent) should be applied to all bolt
holes.
• If tightening torque cannot reach to the specified torque due to
weak transom material, it is necessary to reinforce the tran-
som board with an attachment plate.
MOUNTING TO THE TRANSOM
DF150/175, DF200/225/250
Contained parts
SUZUKI highly recommend to use six mounting bolts for a
rigid-hull inflatable boat or similar application.
Item Part name Part number Q’ty
A
Bolt (12 mm) for
DF60/70, DF90/115
09100-12091 4
A
Bolt (12 mm) for
DF140
09100-12090 4
B
Washer (Large) 09160-12044 4
C
Washer (Small) 09160-12110 4
D
Nut 09159-12014 4
E
Cap 41153-94500 4
Item Part name Part number Q’ty
A
Bolt (1/2-20 UNF) 09100-12086 6
B
Washers
(Large: OD45 mm)
09160-13017 4
C
Washers
(Small: OD26 mm)
09160-13016 6
D
Nut 09159-12062 6
E
Cap 41153-94500 6
F
Washer (with 2 holes) 41153-93J00 2