Suzuki 990D0-44G00-ALM, Fitting Instructions Manual

Page: 4 / 24

PRIOR TO FITTING
1. Check that all the parts shown are included in the Kit.
2. Check the condition of each individual part.
3. Park the vehicle in a stable manner.
4. Take the key out of the ignition.
5. Protect all parts removed from the vehicle.
6. Be careful not to damage any vehicle parts during fitting.
4
State of the art. 01/2007
SUZUKI GENUINE ACCESSORIES
CAUTION
The condition to assemble parts is technical experience.
If you not sure if you do a special work step, you should ask your next SUZUKI dealer.
NOTE
The original wiring harness for GSR 600 model, is equipped with two connectors.
They are dedicated for Alarm System. The features of these two connectors are; one-way connector
and four ways connectors with plastic cover.
They are located on the left side, behind of the left lateral plastic body.
Photo 1: Take off the cover of the ignition key unit (A) , remove the two semi-fairings enclosing the right
and left sides of the tank (B).
Photo 2: Remove the two fairings on the right and left sides ( C ), take off the saddle ( D ) and lift up the
tank ( E ).
NOTE
Use the rod provided to hold the tank up safely.
Photo 3: Cut the double-sided adhesive tape (F) in half but do not remove its protective backing.
Connect the connector on the alarm’s harness up to the control unit, insert the rubber hood into its
housing and secure it using a cable grip
(G).
STEP-BY-STEP FITTING GUIDE
EN
Fitting Instructions
NOTE
Do not remove the other side of protective backing
Photo 4: Clean and remove any grease on the part of the chassis where the control unit will be fitted,
with the siren’s mouth facing downwards . Attach the two pieces of double-sided adhesive tape ( H ) you
cut earlier.
Photo 5: Put the alarm assembly into position (with the siren’s mouth facing downwards) and press
down firmly on the bottom of the alarm case for at least 20 sec.( I).
Secure the alarm harness using a cable grip (L=260 mm) onto the chassis cross bar under the filter box
(L).
Run the two cable lines towards the front of the vehicle: the shorter one goes to the left, the longer one
must cross the vehicle on the right side
(M) . Secure the cable using cable grips (L=140 mm).
On the left, connect up the two way connector (direction indicators) on the alarm harness with the matching
connector on the original wiring. Secure the connector using a cable grip (L=140mm) (N).
Make sure the black two-way connector remains visible for the connection of the LED
(O).
Photo 6: On the right, connect up the two-way connector (direction indicators) on the alarm harness with
the matching connector on the original wiring. Secure the connector using a cable tie (P) .