SUZUKI GENUINE ACCESSORIES
2
Contents
Tools
Ref. Description
Q.ty
1 Main
unit
1
2 Wired
led
1
3 Installer – User instructions
1
4 Cable
tie
3
10
1. Park the motorbike steady in a safe place.
2. Keep the ignition key removed.
3. Be sure not to damage any vehicle part.
4. Check that all the parts are contained in the kit as shown in “Contents” section.
Read this instruction manual carefully. “Special” information is described with the following
symbols/words. Take care of these points.
WARNING
Shows risk for your life and health.
IMPORTANT
Show risks which can damage your bike.
REMARK
Contain special information to fit/maintain parts easily.
IMPORTANT
It is necessary to disconnect the negative pole of the battery before connecting wires.
The system is planned for motorbikes having 12V battery.
Installation and connections should be done by high professional qualified personnel only. If you do not feel technical
qualified to install this product on your own, please consult with your nearest SUZUKI dealer.
1. Technical
features
Supply voltage
12 V dc
Absorbed current
0,2 mA
Operating temperature -40°C / +85°C
2. Preliminary
operations
Dismount the shield (
picture 2
) in accordance to the owners manual (page 6/29).
3. Connections
(see picture 1)
1)
Fit the alarm system by using the hexagonal-head screw on the bike (
picture 4
).
2)
Disconnect the two wires from the horn and connect the
orange/black
wire to the
blue
wire of the alarm system.
Then connect the
black/green
wire to the
green
wire of the alarm system.
3) Connect
the
blue/black
and
green/black
wires of the alarm system to the horn.
4)
Identify the 4-pin connector (
picture 5-A
) of the alarm system prearrangement and insert the alarm harness
counterpart.
5)
+ 12V
: identify the 1-pin connector (
picture 5-B
) and insert alarm the harness counterpart.
6)
Place the led as shown in
picture 3
.
7)
Secure all cables by using the provided cable ties to prevent damages.
8)
Replace all parts you removed earlier from the motorcycle.
4. System
test
1) Put ignition key in ON position for few seconds, and then in OFF position.
2) 30 seconds from the engine cut off, the system is
automatically
arming: LED is blinking.
3) Simulate a theft attempt: remove the motorcycle from its stand and move it for few meters. The system detects the
movement and the horn sounds for 30 sec. (it is possible to deactivate the system before 30 sec. giving 3 consecutive key
turns ON-OFF).
4) End of testing.
INSTALLATION
Important
Before
installation
PH2
GB
