Manual Round video topper
version 1.7
Page 10
11. Display size
The topper uses a regular 5:4
–
1280x1024px -
19” TFT screen. Only it
is mounted on it’s side in the topper. The
screen is also connected via a regular
VGA connector to a computer output.
The screen in the topper will function
like any other desktop PC TFT screen.
For your game content you have to be
aware that you need to rotate everything
90 deg.
See picture for an approximation of the
viewable area’s. The hatched areas
show where you will be able to see
game content.
Always check video on a real topper to
verify a correct result.
12. Tower light brackets
There are several plugs which fit the tower light hole at the rear of the round topper. From left to right.
1. Lid closes the hole for when no tower light is used. There is a hook for easy retrieval of the
tower light cable. Plug can be removed using a flat screw driver.
2. Horizontal mount plug. Mount the tower light on this and then mount the plug in the round
topper. No need to open the topper to mount or service the tower light.
3. Slanted plug. For when the round topper is mounted under a slight angle.
13. Light show control
The round topper has a circular LED strip and a pointer. Both LED light emitters can be controlled via
a serial interface. The bus used for this is CCtalk, common in many gaming machines. When no
CCtalk bus is available a RS232 bus can be used. When a RS232 bus is used however you need
extra hardware. The part for this is 107-0250. RS232 to CCtalk interface.