Sutter Instrument Lambda 10-2, Operation Manuals

Page: 9 / 70

LAMBDA 10-2 OPERATION MANUAL – REV. 2.04 (20120224)
1
1.
1. 1.
1. GENERAL
GENERAL GENERAL
GENERAL
1.1 1.1 1.1 1.1 Introduction Introduction Introduction Introduction
The Lambda 10-2 is an optical filter wheel system designed for rapid change of wavelength
and comprises two subsystems: A controller and one or two filter wheels, each with or
without a shutter, that are to be placed in the optical pathway of your existing experimental
setup. Next is a description on how this manual is organized and the manner in which its use
is intended, followed by a general and functional description of the system.
1.1.1
1.1.1 1.1.1
1.1.1 How to Use this Manual
How to Use this Manual How to Use this Manual
How to Use this Manual
This manual is organized in a manner that is best suited for the typical manner in which the
reader would learn about the system, and then install, operate, and maintain it. Prior to the
table of contents of this manual is a disclaimer and a series of cautionary and warning notes
that should be read first. This first chapter provides an overall description of the system,
leaving more in-depth technical information towards the end of the chapter. The next
chapter describes how to install the system, followed by one or more chapters that provide
operation instructions, and ending with a chapter on maintenance. Following the final
chapter are several appendices that provide supplemental information. The installation
chapter covers everything related to installation, from unpacking the equipment as received,
through to ensuring that everything is correctly installed and is operating correctly. The
operation chapters cover the two basic types of user interaction with the system: Manual
(local) control and external computer control. Please take the time to read these instructions
to assure the safe and proper use of this instrument.
1.1.2 1.1.2 1.1.2 1.1.2 Technical Support Technical Support Technical Support Technical Support
Unlimited technical support is provided by Sutter Instrument Company at no charge to our
customers. Our technical support staff is available between the hours of 8:00 AM and 5:00
PM (Pacific Time) at (415) 883
(415) 883 (415) 883 (415) 883----0128 0128 0128 0128. You may also E-mail your queries to info@sutter.com .
1.2 1.2 1.2 1.2 General Description General Description General Description General Description
The LAMBDA
LAMBDA LAMBDA
LAMBDA 10
10 10
10----2
2 2
2 is a microprocessor controlled, high-speed optical filter wheel designed
for microscopy and other applications, which require rapid and accurate wavelength
switching. The LAMBDA
LAMBDA LAMBDA
LAMBDA 10
10 10
10----2
2 2
2 supersedes the previous Lambda 10 filter wheel controller
providing enhanced capability while retaining the same outstanding mechanical
performance. The Lambda 10-2 controller can control up to two filter wheels and two high-
speed shutters, and provides for both manual (local) control as well as external computer
control (via either of the provided serial (RS-232) or parallel interfaces).
The controller system is designed around three embedded microcontrollers: one slave for
each wheel and a master for control and communication. The electronics for two wheels and
two shutters are already installed, even if you only ordered a single wheel system. If you add
a second wheel or shutter later, there will be no additional electronics to buy. The embedded
microcontrollers automatically determine the number of filter wheels that are installed, so
there are no jumpers or switches to set.