SWD030 Inclusive Roundabout
Installation Instructions
Sheet 3 of 6 Rev 01
Safety Surfacing
Area 28.5m2
Perimeter 20.5m
HIC 1m
This product is not
suitable for installation
into loose fill surfaces.
Installation Procedure
8. Install the lower part of the centre pole. It's important that this is vertical, exactly in the centre of the ring, and the top
surface is level with the top of the stainless steel upper ring sections.
9. Do not install safety surfacing until the top assembly has been installed incase adjustment is needed.
10. When the concrete has set (2 to 3 days) the top assembly can be lowered onto the base ring. Ensure that both
the vertical and horizontal faces of the track ring are clean and free from debris and there is sufficient clearance below
for the guide wheels. Take care when lowering the top assembly that it is central to prevent damage to the four guide
wheels.
11. Ensure the roundabout rotates freely. The gap between the edge of the inner ring to the upper ring sections should
be no more than 8mm but must also not touch. This has been preset at the factory and should not require adjustment on
site.
12. If the roundabout is not rotating freely, follow the adjustment instructions attached.
13. Fit the deck/handrail assembly by bolting through to the frame with the security screws provided. Fit the two
wheelchair rubber stops.
13. Fit the top part of the centre pole using the four M12 countersunk screws. Use the additional packing washers
supplied between the joint if required to ensure the centre pole lower plate does not rub on the deck.
14. Do not allow the roundabout to be used until the required safety surfacing has been installed. When installing the
safety surfacing take care to ensure the surfacing does not push against the upper ring sections. A gap between the
upper ring sections and the rotating frame must be maintained.
Follow the maintenance instructions supplied.
* Care should be taken while installing to decrease the hazard for children.
** Care should be taken if the conditions aren’t normal.
