Step 1: Mount Brackets on V
-
Rack with EZ Roller Pads
(the one with the yellow collars).
•
60mm and 75mm bolts are supplied. Select the
longer bolts for thick crossbars and the 60mm
bolts for thin crossbars.
•
Insert 2 bolts in the V
-
Rack as shown (Fig. 1).
Put an underside bracket on each bolt (you may
need to push a little). Secure loosely with a
washer and T
-
Knob.
Bolt
Page 2
EZ Roller™ V
-Rack
Customer Service:770-518-0045
Fax: 770-518-8507
Website: www.suspenz.com
Suspenz®, Inc.
8725 Roswell Road #0-220
Atlanta GA 30350
This carrier mounts to an existing crossbar on your vehicle. Suspenz carriers are compatible with factory
mounted crossbars and with after market crossbars.
The crossbars must be spaced a minimum of
24”
apart.
Do not exceed the vehicle manufactures rated loading for roof racks shown in the owners manual.
For factory installed crossbars add the weight of these Suspenz roof racks (13 lbs. for two) to the
weight of your watercraft and compare to the allowable load in the owners manual.
For after market crossbars, add the weight of the crossbars to the weight of these Suspenz roof
racks (13 lbs. for two) to the weight of your watercraft and compare to the allowable load in the
owners manual.
1
Note: If the 75mm bolts are not long enough, contact Suspenz as 100mm bolts are available.
Step 2: Install V
-
Rack with EZ Roller Pads on back
crossbar of vehicle.
•
Place the V
-
Rack on the back crossbar of the
vehicle with the yellow collars at the rear of the
vehicle. These rotating EZ rollers are the first
point the watercraft will touch during loading
(Fig. 2)
•
Swing the brackets around, push bolts into the
brackets, and secure with a washer and T
-
Knob.
2
