a. dRill holes in mounting boaRd
b. assemble RoPe oRganizeR
FRONT WALL
TOP PLATE
PIGTAIL LAG
SCREW
PIGTAIL LAG
SCREW
ROPE ORGANIZER
WELDED
SCREW EYE
Diagram 12.
If distance to front wall is less than distance
needed to lift boat, move the Welded Screw Eye (A) along
the front wall until distance 2 is equal to distance 3 (see
Diagram 11).
Diagram 9.
Center Rope Organizer Plate (K) between the
two Pigtail Lag Screws (B) on front mounting board. Use
as template to mark center holes.
Drill two 5/32" (4 mm) holes.
Organizer
Plates
(K)
Organizer
Pulleys
(L)
Washer
(J)
Lag Bolt
(I)
Washer
(J)
Lag Bolt
(I)
Diagram 10.
Assemble Rope Organizer using Plate (K)
and Pulleys (L). Fasten to mounting board with
Lag Bolts (I) and Washers (J).
ImPORTANT:
Do not over-tighten bolts. This can keep Rope
Organizer Pulleys (L) from turning properly.
steP 4: install RoPe oRganizeR
steP 5: assemble hoisteR system
a. install Welded scReW eye (a)
PLAcEmENT ON FRONT WALL
Front
Wall
Ceiling
2
3
Diagram 11.
Distance 2 must be equal or somewhat greater
than distance 3. See chart below. For a larger view, see
Diagram 3.
maximiziNg LoweriNg of Boat
You may want to lower boat to floor, car or the Suspenz
boat Stands. If distance 2 is much greater than 3, the
amount boat can be lowered will be limited by length of
supplied rope. When distance 2 is much greater than 3,
purchase longer rope for drop ropes (H) to maximize
distance boat can be lowered.
If Distance 2 is Distance 3 will be If Distance 2 is Distance 3 will be
10
10
14
6
11
9
15
5
12
8
16
4
13
7
17
3
