Start-up / Operation
Adjustment system - Installation Instructions
Page 42
Storing the memory positions:
Move to the desired position and press the "M" key three times and then press the Key 1, 2 or 3.
The controller acknowledges the successful storage of the position with a signal tone. The memory
position is retained even after a power failure.
Repeat the procedure described to store new memory positions.
7.5
Perform Reset
A reset must be performed both during the initial start-up and upon a power failure during the
process. This is used to protect the workplace. Proceed as follows:
On the manual switch, press both direction keys simultaneously.
The workstation moves at a slow speed until the lower mechanical end stop on the lifting
elements is reached.
The controller acknowledges this reset drive with a signal tone.
The workplace can now be moved with the two direction buttons on the manual switch.
IMPORTANT
If the Height Adjustment System does not function immediately, disconnect
power from the unit and contact the authorized dealer.
IMPORTANT
Do not disassemble the system, unless authorized by the SUSPA GmbH. Any
attempt to repair the system or the system components without the authorization of SUSPA GmbH
will void the warranty.
7.6
Faults and Error Indications
WARNING
Risk of hand injury as a result of failure to observe the danger zone
There are risks of injuries resulting from improper conduct. Never remove wedged parts or for-
eign bodies with your bare hands.
Use suitable aids.
