3. Check the abrasive
disc speed. Don’t use
a disc which speed
range is less than the
indicated on the label
machine.
4. Press the spindle
lock button, to prevent
movement.
5. Press and hold the
spindle lock button;
adjust the exterior
adapter screwing on
the clockwise direction
with the spanner.
To remove:
1. Press the shaft lock button.
2. Loosen the shaft lock nut by turning the nut
counterclockwise with the wrench.
3. Remove the outer flange screw.
4. Release the abrasive disc of the shaft.
TURN ON & TURN OFF
CAUTION: Make sure the switch can be con-
trolled freely and keep it off before connect
the grinder.
The switch function
is the same as a lock-
on button. Slide the
switch to "I" position
and immediately will
be locked to work with
continuous operation,
to unlock press the
switch button and re-locate it to its original
position ("O").
Move only to the work piece then of turn on
the tool.
When the carbon brushes are worn, the tool
will turn off automatically.
When use a new abrasive disc, leave the ma-
chine run for a few minutes without load.
OPERATION INSTRUCTIONS
1. For best control, hold the angle grinder firm-
ly with one hand gripping the side handle and
the other gripping the rubber-coated grip on
the body of the angle grinder.
NOTE: The starting torque creates a sudden
jerk.
2. Always position the guard so that the ex-
posed grinding disc is pointing away from the
operator.
3. After starting the tool, apply the grinding
disc to the workpiece.
NOTE: Do not turn the angle grinder “ON”
or “OFF” while the grinder is in contact with
the workpiece. It will decrease the life of the
trigger switch and could cause damage to the
workpiece.
NOTE: Be prepared for a stream of sparks when
the disc touches metal.
4. Tilt the angle grinder at a 15º to30º angle for
easy handling and smooth grinding.
This will make it easier to remove the disc from
the workpiece, and will prevent unnecessary
overloading.
5. Apply the grinding disc to the work surface
using light, steady pressure for grinding effi-
ciency.
WARNING: Do not apply unnecessary pres-
sure. The weight of the tool applies adequate
pressure. Excessive or sudden pressure will
overload the motor, cause a drop in the speed
and put dangerous stress on the grinding disc,
possibly causing breakage and injury.
6. When using a new grinding disc, do not
move the disc in a forward direction (A) on the
workpiece. Doing so will cause the edge of the
disc to cut into the surface of the workpiece.
While grinding, the direction of movement
should be backward, toward the operator (see
image above).
WARNING: Do not use a disc with a centre
indentation after it has been worn to a 3” di-
ameter. The continued use of a worn-out disc
may result in disc explosion and serious injury.
WARNING: Before each use, inspect the
angle grinder, the ON/OFF trigger switch, and
the cord for any damaged, missing, or worn
parts. Check for loose screws, misalignment or
binding of moving parts, or any other condi-
tions that may affect the operation. If abnor-
mal vibration or noise occurs, turn the tool off
immediately and have the problem corrected
before further use.
12
EA604B manual.indd 12
25/06/15 9:08
