MAINTENANCE
BEFORE ALL CARE AND MAINTENANCE WORK
• Turn the machine off.
• Wait until the machine has come to a com-
plete standstill.
• Pull out the power plug.
REPLACEMENT PARTS
Parts which were not reviewed and approved
by the manufacturer can damage the machine
and can cause serious injuries.
Use only original parts for replacing old parts,
particularly for safety mechanisms and cutting
tools.
CLEANING
Clean the machine regularly after each use
from dust, shaving, wood splinters, etc.
Clean the machine with a moist cloth and some
soft soap. Do not use any detergents or solu-
tion; these may cause corrosion of the plastic
parts of the machine. Make sure that no water
reaches the inside of the machine.
INSPECTION OF THE SCREWS
Inspect all screws and ensure that they are fully
tightened. If any screws are loose, retighten
them immediately.
MAINTENANCE AND REPAIR
All quality power tools require occasional
maintenance service or replacement because
of wear from normal use. To ensure that only
authorized replacement parts are used, all
maintenance and repairs must be performed
only by AUTHORIZED SERVICE CENTER.
INSPECTION OF CARBON BRUSHES
The engine uses carbons, which are spare parts.
Replace the brushes with new ones when worn
to its limit. Always keep the carbons clean to
ensure that they slide freely within the brush
holder.
TROUBLESHOOTING
IF MOTOR DOESN’T START
Brushes worn: Have carbon brushes replaced
by an authorized service center.
13
TECHNICAL DATA
IF MACHINE WILL NOT CUT OR LEAVES A ROUGH
FINISH
Blunt blades: Replace blades.
Wood is wet: Leave wood out to dry.
IF YOU FEEL A LOSS DRIVE
Worn or broken drive belt: Replace belt.
IF THE MACHINE DOESN’T CUT TO THE CORRECT
DEPTH
Blade adjustment is wrong: Adjust blades.
VOLTAGE-FREQUENCY
NO LOAD SPEED
PLANING CAPACITY:
WIDTH
DEPTH
POWER
POWER CONSUMPTION
WEIGHT
120 V ~ 60 Hz
16 000 r/min
3 1/4” (82 mm)
3 mm
800 W
0,4 kWh
2,8 kg (6,17 lb)
E N G L I S H •
User’s manual
CE403B manual.indd 13
28/05/15 15:46
