3
E N G L I S H
INTRODUCTION
Do not use for thin wall tubes, inox or chromed pipes,
exhaust pipes, precision pipes etc as tubes can get
damaged.
• Read carefully these instructions prior to use.
• Do not exceded the max capacity.
• Do not introduce any part of the body in the work area.
• Use security gloves, goggles and boots.
• Use oil HL or HM.
• Repair by qualified persons.
• This unit has been designed for bending pipes only and must
not be used for other purpose.
• If these basic rules are not followed, injury to the user or
damage to the unit or the pipe may result.
PARTS LIST
1
Handle
2
Pipe support
3
Frame
4
Pipe
5
Shoe
6
Cap
7
Hydraulic jack
of pipe bender
8
Pipe support
pin
9
Screw
10
Pin
OPERATION INSTRUCTIONS
1. Selet required bending shoe and place on end of
ram.
2. Place conduit in bending shoe and locate pipe
supports at the correct holes in the frame. Insert
pipe support pins.
3. To work with 12 ton hydraulic pipe bender.90° can
be made by ½", ¾", 1", 1 ¼", 1 ½" and 2” bending
shoes with bending shoe properly.
4. To work with 15 ton hydraulic pipe bender. 90°can
be made by ½", ¾", 1", 1 ¼", 1 ½", 2", 2 ½ and
3" bending shoes with bending shoe properly. 90°
can 't be made by 2 ½" and 3" bending shoes by
one shot.
Decide how many shots have to be made according
to developed length. and make certain mark on
the conduit. The number of marks depend on the
size and thickness of conduit.
Developed Length = 0.01745 x Radius x Degrees.
Formula for making 90° Bends is: Radius x 1.57 =
Developde Length.
Space= Developed Length÷ Number of Marks.
5. Place handle handle over release vlave and turn
clockwise to close. Insert handle into handle
shocket and pump to bend conduit.
CAUTION: Do noto verfill the bending shoe.
6. Turn release valve counter-clockwise and suitably
return ram into cylinder. Shift conduit to the next
dending postion.
7. Move the one pipe support nearer pipe on bent
end in proper alignment with pipe and make
additional bends.
MAINTENANCE
1. Lubricate all moving parts at regular intervals.
2. Always keep the pipe bender clean and protected
from aggressive conditions.
IMPORTANTE: AN EXCESS OF OIL WILL RENDER
THE HYDRAULIC UNIT INOPERATIVE.
3. Use only hydraulic oil, HL or HM type.
IMPORTANTE: NEVER USE BRAKE FLUID.
REPAIR
Both maintenance and repair must only be carried out
by qualified and approved personnel.
