DO NOT use an extension cord or plug adapters. These
actions may result in a fire hazard or electric shock.
DO NOT operate this unit with damaged power wires. If
the power wires are damaged it must be replaced by the
manufacturer or a qualified/licensed service technician.
DO NOT use this unit to circulate fluids, solids, gases, or
any other substance that is not expressly permitted. This
fan is designed for air ventilation only.
This unit must be connected to a protective earthing
system prior to operation. DO NOT remove the grounded
connection while power is being supplied to the fan.
Doing so presents an electric shock hazard to users and
service personnel.
All wiring must be in accordance with the National
Electrical Code, ANSI/NFPA 70 and local electrical codes.
Electrical installation should be performed by a qualified
electrician.
Ensure that power is off before installation or performing
work on the unit.
To reduce the risk of fire or electric shock, do not use this
unit with any solid-state speed control device.
To reduce risk of injury, it is recommended to mount the
fan at least 10 feet (3.1 meters) above the floor.
This device is intended for indoor use only and should be
protected from rain and flooding.
This equipment is not meant for connection to a duct
system.
A minimum clearance of 36 inches (915 mm) shall be
provided around the fan intake and 72 inches (1,828 mm)
around the shroud to ensure proper air flow and servicing.
After installation, service and maintenance personnel shall
be able to access the power supply and fan blades.
Prior to installation, care must be taken to ensure the
structural integrity of the supporting members when
mounting the fan. Verify the load bearing capacity of any
mounting surface is rated for the load of the Ventilator.
8
Summary of Contents for S-DSVF-115V
Page 15: ...ELECTRICAL FIGURE 5 Connection Diagram 1 5...
Page 19: ...NOTES 1 9...
