20
4�5 CONTROLS
Please review this section to familiarize yourself with the location and function of each control before starting.
Familiarizing yourself with the controls will enable you to take advantage of all the features available on the
SMC and apply them as conditions demand.
Before starting to work, all operators should familiarize themselves with the location and function of controls.
4�5�1 ENGINE:
A Honda and
GC190
Honda engine is used on the
SMC32S
. Controls on the engine are shown il-
lustrated below.
Always read the manufacturers engine operator's manual before starting work for more detailed
instructions and maintenance�
Throttle / Ignition Switch:
GC engines are equipped with a
throttle, slide it up to increase en
-
gine RPM, down to decrease.
To shut the engine off, move the
throttle to the very bottom position.
Choke:
The choke controls the fuel/air
mixture to the engine. Close the
choke when starting if the engine
is cold. (
pull out
) Open the choke
as the engine warms.(
push in
)
Always open the choke fully during
operation.
Starting rope:
This retracting rope and T-bar is used to
turn the engine over for starting. Grasp
the T-bar firmly and pull the rope sharply
to start the engine.
