Use the Cross Base with your parasol
if you do not wish to carry out an inground
fitting. The Cross Base allows you the
flexibility to move the parasol around.
However it should only be used in light
wind conditions.
1. Unpack two cross base sections
and install the 4 end plates with the
screws provided
(refer Figure A).
2. Lay the top section (cut out facing
down) over the bottom section (cut
out facing up)
(refer Figure B).
3. Place the parasol spigot onto the
cross base, lining up the four holes
in the spigot plate with the four holes
on the cross base
(refer Figure C).
Figure A
Figure B
Figure C
MOBILE INSTALLATION
