396-4519Y1 Sentinel NH3 Blockage Monitor
23
Revised 01/26/2022
© 2016-2022 SurePoint Ag Systems Inc.
F
Setup &
Operation
D
Setup &
Operation
Speed Input and Calibration
Sentinel Setup and Configuration
Hardware
Select Hardware Options:
Master Switch--
Check only if there is a dedicated
Master Switch plugged into the Sentinel. (Not typical)
Lift Switch
- check ONLY if the Sentinel has a
dedicated lift switch plugged into the Sentinel
harnessing. The switch used by your rate controller IS
NOT used by Sentinel. If using a dedicated lift switch,
the implement position indicator will appear on the
HOME screen.
Pump Speed
- for liquid products.
Task Control
- permits Sentinel to use available task
control information on the bus regarding section control.
ENABLE TASK CONTROL if Task Control is available
from your display.
IntelliSection
- enabling IntelliSection allows the
Sentinel to determine when sections are turned off by
looking at temperature across the entire section. When
the average temperature across the section raises,
alarms for those rows are disabled.
Check this box if
not using Task Control.
If using IntelliSection, you
should also use a Lift Switch on the Sentinel.
Go BACK.
Select Speed Source:
Ground Speed (default)
- GPS speed or speed
posted by the tractor ECU
Wheel Speed
- speed of the tractor wheels. Slip is
not accounted for.
Machine Selected Speed
- user-defined speed
posted by tractor ECU
Simulated Speed
- to perform stationary flow
tests, a simulated speed must be entered
ECU Input Speed
- alternate speed input on Senti-
nel ECU harness can be plugged into a wheel-
speed sensor or GPS speed receiver.
Speed Calibration
- used to calibrate the ECU in-
put speed source.
NOTE: If the selected speed source does not cause
Sentinel to display speed, choose another source
until speed is displayed.
PRESS HERE
Speed Setup Screen
Hardware Setup Screen
SurePoint
Ag
Systems