Volcano Plus Revised August 2008
6
To install the circulating chamber:
1.
Lower the liner to 24 inches from the hearth.
2.
Fill the space above the smoke chamber with Roxul to prevent heat from
escaping to the chimney.
3.
Adjust the sides of the circulating chamber to the width of the existing
fireplace.
4.
Insert the circulating chamber in the existing fireplace and lower the liner
through the adjustable hole of the circulating chamber.
5.
Adjust the height of the circulating chamber to the height of the existing
fireplace. If the height of the existing fireplace is greater than that of the
circulating chamber, fill in the area between the top of the circulating
chamber and the top of the existing fireplace with Roxul.
6.
Install the liner adaptor at the end of the liner.
7.
Slide the fireplace insert into the circulating chamber and guide the adaptor
into the liner opening of the insert. Secure the adaptor using the wing nuts.
8.
Adjust the insert to have a distance of 10.5 inches from the front of the liner
to the surround of the fireplace.
9.
Install the surround. Level the insert by using the levelling screws provided.
3-
METAL TAG INSTALLATION
Fix the metal tag warning with screws or nails on the fireplace hearth. The tag must be readily visible should the fireplace
insert be removed.
Note: The fireplace must be inspected by a qualified person prior to re-use as a conventional fireplace.
4-
FIREBOX INSTALLATION
Note: To facilitate installation, remove the door from the firebox. To remove the door, start by pulling out the lower pin end
until it is removed from its hole. Then, lower the door until the upper door pin end is removed from its hole.
a)
Slide the firebox in the fireplace.
b)
Adjust the firebox height and level by screwing/unscrewing the three bolts of the firebox bottom.
c)
Insert the flue collar in the firebox top.
d)
Align the flue collar flange with the three studs and fasten with nuts.
e)
Install the face and fix it with four self-tapping screws, two on either side of the face.
f)
Install the door.
g)
Inspect the installation and level if necessary using the adjustable legs.
Note: The adjustable legs are accessible from the inside of the firebox and can be adjusted with a flat screw driver.
OPERATION INSTRUCTIONS
Important note: This fireplace insert has been designed to only burn with the door closed.
WOOD
The VOLCANO PLUS fireplace insert is designed to burn good quality, dry cordwood. The suggested length of a log is 18 in.
and should preferably be in halves or quarters. Excessive moisture content in firewood causes excessive creosote deposits in the
chimney, which could lead to a chimney fire. Cordwood should be split and left to dry one year prior to use.
DO NOT burn coal, construction lumber, plastics, garbage or other foreign materials in your fireplace.
Never use gasoline, gasoline type lantern fuel, kerosene, charcoal lighter fluid, or similar fluids to start or "freshen up" a fire.
Keep all such liquids well away from the fireplace insert while it is in use.
