Volcano Plus Revised August 2008
10
3.
Take out the door gasket in order to get access to the nuts fixing the glass supports to the door frame.
4.
Remove the nuts, the glass supports and the glass gasket.
5.
Take off the broken pieces from the door frame using pliers. Watch for cuts. Clean the frame carefully to insure that it is
free of small fragments.
6.
Insert the new glass into the door frame: it must be centered in such a way to avoid contact between the glass and the
supports.
7.
Apply a bead (width between 1/8” and 5/32”) of high temperature silicone on the glass while following its outline and fix
on it the new glass gasket.
8.
Fix the glass supports to the door frame. Do not over tighten the nuts.
9.
Clean the slot embedding the door gasket and apply on the bottom of the slot a bead (width between 5/32” and 3/16”) of
high temperature silicone.
10.
Install the new door gasket in the slot.
WARNINGS:
Never operate the VOLCANO PLUS without a gasket or with a damaged one.
Do not use substitute materials.
GLASS CLEANING
The glass door should be cleaned with a soft cloth, using a non-abrasive solution such as soap and water, if necessary.
Abrasive cleaners will produce surface scratches and reduce panel transparency and resistance to impacts. Commercial glass
cleaners such as KEL KEM give better results.
The glass should be cleaned when the fireplace is not in use. Do not clean glass when it is hot.
FANS
The VOLCANO PLUS fireplace insert is equipped with two factory installed fans thermostatically controlled.
Plug the power cord into the nearest 115 Volts outlet.
REMOVAL OF THE FIREPLACE INSERT
For the purpose of inspecting the fireplace insert and the fireplace, it is possible to remove the insert.
WARNING:
To avoid possible burns, make sure the fireplace insert is cold before its removal.
1.
Remove the ashes from the firebox.
2.
Unplug the blowers’ power cord.
3.
Remove the door and unscrew the four screws (two on each vertical mount of the face), which fix the face to the firebox.
4.
Remove the face.
5.
Make marks to facilitate the reinstallation of the firebox.
6.
Unscrew the three nuts fixing the flue collar to the firebox top.
7.
Push up the flue collar until it goes out of the firebox top.
8.
Slide the firebox out of the fireplace.
