Supreme Heating Heatseeker NovaS, Installation & User Manual

Page: 26 / 44

E08 Communication Fault
Communication failure between
wire controller and mainboard
Check the wire connection
between remote wire
controller and main board
P09 Antifreeze Temp. Sensor Fault
Antifreeze temp sensor is broken
or short circuited Check and replace this temp
sensor
E05 Waterway Anti-freezing Prot.
Water temp. or ambient temp.
is too low
F051 EC fan feedback Fault
There is something wrong with
fan motor and fan motor stops
running
Check whether fan motor is
broken or locked or not
PP Pressure sensor Fault The pressure sensor is broken
Check or change the pressure
Sensor or pressure
F031 Fan Motor1 Fault
1. Motor is inlocked-rotor state
2. The wire connection between
DC-fan motor module and fan
motor is in bad contact 1.Change a new fan motor
2.Check the wire connection
and make sure they are in
good contact
TP Low AT Protection Ambient temp is too low
F032 Fan Motor2 Fault
1. Motor is inlocked-rotor state
2. The wire connection between
DC-fan motor module and fan
motor is in bad contact 1.Change a new fan motor
2.Check the wire connection
and make sure they are in
good contact
E081
Communication Fault
(speed control module)
Speed control module and main
board communication fail Check the communication
connection
Frequency conversion board fault table
DISPLAY FAILURE DESCRIPTION REASON SOLUTION
F01 Drv1 MOP alarm MOP drive alarm Recovery after the 150s
F02 Inverter offline
Frequency conversion board
or main board communication
failure
Check the communication
connection
F03 IPM protection IPM modular protection Recovery after the 150s
F04 Comp. Driver Failure
Lack of phase, step or dirve
hardware damage
Check the measuring voltage
check requency conversion
board hardware
F05 DC Fan Fault
Motor current feedback open
circuit or short circuit Check whether current return
wires connected motor
F06 IPM Overcurrent IPM input current is large
Check and adjust the current
measurement
F07 Inv. DC Overvoltage
DC bus voltage>Dc bus over-
voltage protection value Check the input voltage
measurement
Heatseeker NovaS Heat Pump
Installation & User Manual
24