von-Drais-Straße 7 • D-55469 Simmern / Hunsrück • Tel: +49 6761 96509-00 • Fax: -01 • www.oxyflex.de • [email protected] (Status Dec. 2018)
Type "SA": Fitting to square pipes with holes at side
The OXYFLEX
®
- MF1100 type 'SA' membrane plate diffuser is secured using side adapters to square pipes with
two bore holes in the side.
A flat gasket made from EPDM is inserted between the square pipe and the side adapter or the square pipe and
the counter piece. The surfaces must be clean and straight; the gaskets must sit clean and undamaged between
the adapter and the pipe.
The side adapter is inserted into the 38 to 45 mm diameter bore holes at the sides and screwed in place with the
counter piece at the opposite side using an M10 hexagonal through-screw (16 Nm). The thread of the hexagon
screws have to be lubricated beforehand to avoid seizing.
An O-ring made from EPDM is inserted between the side adapter and the connecting thread of the diffuser. The
gasket between the diffuser and the adapter must be clean and undamaged.
The OXYFLEX
®
- MF1100 type 'SA' membrane plate diffuser is screwed into the 2" thread of the side adapter in a
secure and stable way using the air-socket. In order to secure the installation position firmly, 2 additional non-twist
angles are screwed into the lugs of the frame (M6 x 35 mm)
Always make sure that the diffuser is firmly and horizontally seated.
Possible square pipe dimensions:
Height: 80 mm, 100 mm, 120 mm
Width: variable
(Further sizes are available on request.)
