Superwinch Certus Wireless, Owner'S Manual

Page: 7 / 18

Do not attempt to install wiring when the battery is connected.
Do not lean over battery while making connections.
Automotive batteries contain flammable and explosive gases. Wear eye
protection during installation and remove all metal jewellery.
7
Ensure that the wiring harness does not interfere or come in
contact with any hot or moving engine, suspension, steering,
braking or exhaust parts.
CAUTION
!
INSTALLATION INSTRUCTIONS
Step 1
Disconnect the battery before beginning installation.
Step 2
Locate a place to mount the Wireless Control unit. Under dash, console, or inside
wall of a box trailer would be typical locations. The unit can be mounted in any
orientation inside the vehicle or trailer. The unit can be mounted by either
cable ties or four (4) self-tapping screws.
Step 3
Connect the white weather pack connector end of the harness to the mating
white weather pack connector on the wireless receiver module. see ( Fig. 4)
Step 4.
For P/N 06705
A. Connect the winch plug end to your Talon winch socket.
For P/N 06707 (See Fig.5)
A. Connect the black wire ring terminal from the harness assembly to
the black (-) stud of the solenoid.
C. Connect the red wire ring terminal from the harness assembly to the
red (+) stud of the solenoid.
D. Use one of the two supplied quick splice connectors to splice the
blue wire from the harness assembly into the black wire from the
handlebar rocker switch.
E. Use the second quick splice connector to splice the yellow wire from
the harness assembly into the green wire from the handlebar rocker
switch.
from the Winch to the Receiver
DANGER
!
Fig. 4
SPANISH
Step 5.
Install battery that came with your control (see battery section)
For P/N 06709:
A. Connect the winch plug end to your S-Series winch socket.