4.
Slide steering bar under curved steering column shaft so that the end of the
steering column shaft fits into the slot in the steering bar.
(See Image D)
5.
Re-Install screw, previously removed in step 1, to attach the steering bar to
axle A. Tighten so nut is snug. (See Image E)
6.
Install the front wheels. Place a flat washer on each front axle shaft. Install one
tire/wheel on each axle shaft. Place a flat washer on each axle and secure with lock
nut. Use tool supplied to tighten lock nut until snug.
7.
Install wheel covers: Set wheel covers into place on the outside of the wheel. Using
the small screws supplied, secure the wheel covers to the wheels through the three
drilled holes in the wheel covers. Do not over tighten to avoid damage to the wheel
covers. (See Image 1)
