10
Mounting and Laminating using a SuperStick® Pouch Board:
1. For specific instructions on mounting/laminating with a SuperStick® board, refer to the instruction
sheet that is packed with each box of SuperStick® pouch boards.
2. Also, refer to the instruction sheet for information on compatible media, process conditions, and
technical information.
3. A SuperStick® pouch board consists of a foam mounting board with a piece of film sealed to the
top of the board.
4. Carefully examine the board, determine which edge is sealed. There is a 1/8” tape edge on the
sealed end.
5. Starting at one of the corners that is opposite to the sealed edge, gently lift and peel back the film.
Care should be taken not to break the sealed hinge.
6. Center the image that you wish to laminate in the pouch and lay the film back over it.
7. Cover your print with the white carrier that has been provided in the pouch board box. This is
required to prevent any adhesive from sticking to the rolls.
8. Set the control knob to the correct setting that matches the pouch board thickness.
9. Slowly insert the pouch board into the inlet opening. Ensure that the pouch board will enter
centered and straight. A gentle push may be required to start the board into the machine. Hold the
edges of the pouch board until it is engaged and the laminator begins pulling on its own.
10. The pouch board will feed through the laminator and automatically exit at the rear of the unit.
11. Support the board as it exits the machine to keep the heated board from curling down.
12.
THE POUCH BOARD WILL BE HOT!
Allow the board to lie flat while cooling.
13. If there is any dirt or adhesive on the surface of the board, it can be removed by dampening a lint
free cloth with Poly-Off and wiping the surface.
Laminator.com
www.laminator.com
