Installation Instructions
Part #SS450 - Rear Trac Bar
C. Installation of the Frame Bracket
On the driver’s side, take frame bracket and install ¾” bolt so that the bolt head will be on the axle tube
side of the bracket (See Figure 2). Install the frame bracket and nut plate to the frame rail. The frame rail
must be between the nut plate and the frame bracket. The frame bracket is designed to mount to the bot
-
tom and sides of the frame rail. Position the bracket directly next to the rear frame cross-member (place
nut plate with lip facing down and towards the center of the vehicle). Make sure not to contact any wires,
brake lines, etc. Install bolts through the bottom of the frame bracket and into the nut plate using supplied
flat and lock washers (just hand tight for now).
Install jam nuts to ½-20 bolts and install on the frame bracket. Tighten to push nut plate securely to the
inside of the frame rail. Next, tighten jam nut against frame bracket. Now tighten the bottom bolts securely.
Figure 2
Frame Bracket Bolt Must Be
Inserted As Seen Above To Prevent
Damage To Brake Line Attached To
Axle.
