Installation Instructions
Part #SS450 - Rear Trac Bar
A. Preparation
Move the coach to a level, flat surface. If necessary, drive the rear wheels of the coach onto 4” high blocks
and set the brakes or you may drive the coach over a work pit and chock the front wheels. Block off ade
-
quate space at the rear of the coach to work.
B. Installation of the Axle Bracket
Begin by removing the 4 bolts, 2 on each side that hold the sway bar on the axle housing.
Take axle bracket and install ¾” bolt so that the bolt head will be on the axle tube side of the bracket (See
Figure #1). On the passenger’s side insert the mounting bracket underneath the sway bar bracket and
re-install bolts (See Figure 1). There are four holes drilled and tapped in the bracket to accept the four
square head set-screws. Put a drop of Locktite on each set-screw and thread into the tapped holes. Tight
-
en the set-screws down equally until they contact the bracket that is welded to the differential. This will
stop the lateral movement of the bracket.
On the driver’s side, insert the spacer plate between the sway bar brackets and the differential (as shown
below). Install bolts supplied in kit.
Figure 1
