Supero X9DRG-HF+, User Manual

Page: 57 / 111

Chapter 2: Installation
2-33
T-SGPIO1
T-SGPIO2
I-SAT
A0
COM1
JSD1
LE4
SW1
JPW10
LAN2 LAN1
JL1
JOH1
JSPK1
JPLD1 JI2C2
JI2C1
JPW7
JPW4
JPW3
JVGA1
JPW9
JPW1
Battery
LE1
DM1
JWD1
J30
JPB1
J29
JPL1
JPG1
FAND FANC
FANB FANA FAN4 FAN3
FAN2 FAN1
FANH
FANG
FANF
FANE
JF1
JPW2
JTPM1
JITP0
SXB1B PCI-E 3.0 X16
SXB4 PCI-E 3.0 X16
CPU2
SXB3 PCI-E 3.0 X16
SXB2 PCI-E 3.0 X16
SXB1C
P1-DIMMA1
P1-DIMMA2 P1-DIMMB1 P1-DIMMB2
P2-DIMMG1 P2-DIMMG2 P2-DIMMH1 P2-DIMMH2
P1-DIMMD2 P1-DIMMD1 P1-DIMMC2 P1-DIMMC1
P2-DIMMF2 P2-DIMMF1 P2-DIMME2
P2-DIMME1
CPU1
IPMI LAN
SXB5 PCI-E 3.0 x8 in x16
SXB1A
JPW
6
JPW5
I-SAT
A1
I-SAT
A2
I-SAT
A3
I-SAT
A4
I-SAT
A5
JBT1
BIOS
PCH
C602J
LAN
CTRL
BMC
X9DRG-HF+
Rev. 1.01
CLOSE 1st
OPEN 1st
CLOSE 1st
OPEN 1st
USB0/1
JPME2
JPME1
CMOS Clear
JBT1 is used to clear CMOS. Instead of pins, this "jumper" consists of contact pads
to prevent accidental clearing of CMOS. To clear CMOS, use a metal object such
as a small screwdriver to touch both pads at the same time to short the connection.
Always remove the AC power cord from the system before clearing CMOS.
Note 1:
For an ATX power supply, you must completely shut down the
system, remove the AC power cord, and then short JBT1 to clear CMOS.
Note 2: Be sure to remove the onboard CMOS Battery before you short
JBT1 to clear CMOS.
Note 3: Clearing CMOS will also clear all passwords.
A. Clear CMOS
B. Watch Dog Enable
Watch Dog Enable/Disable
Watch Dog (JWD1) is a system monitor that will re-
boot the system when a software application hangs.
Close Pins 1-2 to reset the system if an application
hangs. Close Pins 2-3 to generate a non-maskable
interrupt signal for the application that hangs. See
the table on the right for jumper settings. Watch
Dog must also be enabled in the BIOS.
Watch Dog
Jumper Settings
Jumper Setting Definition
Pins 1-2 Reset (default)
Pins 2-3 NMI
Open Disabled
B
A