Chapter 2: Installation
2-13
BAR CODE
JD1
SP1
JIPMB1
JPI2C1
I-SGPIO2
J23
BT1
JI2C2 JI2C1
JBR1
JPME2
JSXB1_3
JOH1
JTPM1
JBT1
J24
JPWR2
JPWR1
JMEZ1
P1_NVME1
JSXB1_1
JF1
LE2
LEDM1
LE1
FAN3
FAN4
FAN5
FAN6
FAN2
FAN1
I_SA
TA4
SXB2:CPU1 PCI-E 3.0 X8
SXB1B:CPU1 PCI-E 3.0 X16 + CPU2 PCI-E 3.0 X16
USB2/3
USB6(3.0)
COM1
S-SA
TA0~3
I-SA
TA0~3
P1 DIMMC1 P1 DIMMC2
P2-DIMME2
P2-DIMME1
P1 DIMMD1
P2-DIMMF1
P1 DIMMD2
P2-DIMMF2
P1 DIMMB2
P1 DIMMB1
P2-DIMMH2
P1 DIMMA2
P2-DIMMG2
P2-DIMMH1
P1 DIMMA1
P2-DIMMG1
LAN2
JUIDB1
LAN1
VGA
USB4/5(3.0)
IPMI_LAN
JSTBY1
CLOSE 1st
OPEN 1st
CPU2
CLOSE 1st
OPEN 1st
CPU1
JWD1
BIOS
PCH
BMC
LAN
X10DDW-i
Rev. 1.10
JPLAN1 JPG1
JPB1
LE3
1
JL1
P1_NVME0
FAN8
FAN7
P2_NVME1
P2_NVME0
I_SA
TA5
USB0/1(2.0)
BIOS
LICENSE
MAC CODE
JSXB1_2
Release Tabs
Notches
2-5 Installing and Removing the Memory Modules
Note
: Check Supermicro's website for recommended memory modules.
CAUTION
Exercise extreme care when installing or removing DIMM
modules to prevent any possible damage.
Installing & Removing DIMMs
1. Insert the desired number of DIMMs into the memory slots, starting with
P1-DIMM A1. (For best performance, please use the memory modules of the
same type and speed in the same bank.)
2. Push the release tabs outwards on both ends of the DIMM slot to unlock it.
Removing Memory Modules
Press both notches on the ends of the DIMM module to unlock it. Once the DIMM
module is loosened, remove it from the memory slot.
3. Align the key of the DIMM module with the receptive point on the memory
slot.
4. Align the notches on both ends of the module against the receptive points on
the ends of the slot.
5. Use two thumbs together to press the notches on both ends of the module
straight down into the slot until the module snaps into place.
6. Press the release tabs to the locking positions to secure the DIMM module
into the slot.
Press both notches straight
down into the memory slot at
the same time.
