Supero SuperServer 6033P-8R, User Manual

Page: 41 / 114

Chapter 5: Advanced Serverboard Setup
5-5
5-3 Connecting Cables
Now that the processors are installed, the next step is to connect the cables to
the serverboard. These include the data (ribbon) cables for the peripherals and
control panel and the power cables.
Connecting Data Cables
The ribbon cables used to transfer data from the peripheral devices have
been carefully routed in preconfigured systems to prevent them from block-
ing the flow of cooling air that moves through the system from front to back.
If you need to disconnect any of these cables, you should take care to keep
them routed as they were originally after reconnecting them (make sure the
red wires connect to the pin 1 locations). If you are configuring the sys-
tem, keep the airflow in mind when routing the cables. The following data
cables (with their serverboard connector locations noted) should be connected.
See the serverboard layout figure in this chapter for connector locations.
!
IDE Device Cable (IDE#2)
!
Floppy Drive Cable (JP7)
!
SCSI Cable (JA1)
!
Control Panel Cable (JF2, see next page)
Connecting Power Cables
The X5DP8-G2 has a 24-pin primary power supply connector designated "ATX
Power" for connection to the ATX power supply. Connect the appropriate con-
nector from the power supply to the "ATX Power" connector to supply power to
the serverboard. The Secondary ATX Power Connector (at J15) must also be
connected to your power supply. See the Connector Definitions section in this
chapter for power connector pin definitions.