Supero SuperServer 6026TT-D6IBQRF, User Manual

Page: 77 / 120

Chapter 6: Advanced Chassis Setup
6-5
Figure 6-3. Removing a Dummy Drive Tray
1 1
1 1
Installing/Removing Hot-swap Drives
1. To remove a carrier, push the release button located beside the drive LEDs.
2. Swing the handle fully out and use it to pull the unit straight out (see Figure
6-5). See the following pages for the logical layout of the hot-swap drives.
Figure 6-4. Mounting a Hard Drive in a Carrier
Drive Carrier
Hard Drive
1
2
1 2
Warning: Enterprise level hard disk drives are recommended for use in Supermicro
chassis and servers. For information on recommended HDDs, visit the Supermicro
Web site at http://www.supermicro.com/products/nfo/storage.cfm