Supero SUPERSERVER 5017R-WRF, User Manual

Page: 45 / 112

Chapter 5: Advanced Serverboard Setup
5-15
5-8 Connector Defi nitions
Power LED
The Power LED connection is located
on pins 15 and 16 of JF1. Refer to the
table on the right for pin defi nitions.
ATX Power Connector
The 24-pin main power connector
(JPW1) is used to provide power to
the motherboard. The 8-pin power
connector (JPW2) is also required for
the processor. These power connec-
tors meet the SSI EPS 12V specifi ca-
tion. See the table on the right for pin
defi nitions.
NMI Button
The non-maskable interrupt button
header is located on pins 19 and 20
of JF1. Refer to the table on the right
for pin defi nitions.
NMI Button
Pin Defi nitions (JF1)
Pin# Defi nition
19 Control
20 Ground
Processor Power
Pin Defi nitions (JPW2)
Pins Defi nition
1 through 4 Ground
5 through 8 +12V
Power LED
Pin Defi nitions (JF1)
Pin# Defi nition
15 Vcc
16 Control
Processor Power Connectors
JPW2 and JPW3 must also be con-
nected to the power supply to provide
power for the processor(s). See the
table on the right for pin defi nitions.
Warning : To prevent damage to your power supply or motherboard, please
use a power supply that contains a 20-pin and two 8-pin power connec-
tors. Be sure to connect these power connectors to the 20-pin and the two
8-pin power connectors on your motherboard for adequate power supply
to your system. Failure to do so will void the manufacturer warranty on
your power supply and motherboard.
!
ATX Power 24-pin Connector
Pin Defi nitions (JPW1)
Pin# Defi nition Pin # Defi nition
13 +3.3V 1 +3.3V
14 -12V 2 +3.3V
15 COM 3 COM
16 PS_ON 4 +5V
17 COM 5 COM
18 COM 6 +5V
19 COM 7 COM
20 Res (NC) 8 PWR_OK
21 +5V 9 5VSB
22 +5V 10 +12V
23 +5V 11 +12V
24 COM 12 +3.3V