Supero SUPERSERVER 5017C-LF, User Manual

Page: 20 / 92

2-6
S
UPER
S
ERVER 5017C-LF User's Manual
2-5 Checking the Serverboard Setup
After you install the server in the rack, you will need to open the unit to make sure
the serverboard is properly installed and all the connections have been made.
Removing the Chassis Cover
Remove the fi ve screws that hold the chassis cover in place.There are two 1.
screws on each side of the chassis, and one screw on the back.
Lift the top cover from the chassis to gain full access to the inside of the 2.
server.
Checking the Components
You may have a processor already installed into the serverboard. The proces- 1.
sor should have its own heatsink attached. See Chapter 5 for instructions on
processor installation.
The 5017C-LF server may have come with system memory already installed. 2.
Make sure all DIMMs are fully seated in their slots. For details on adding
system memory, refer to Chapter 5.
If desired, you can install an add-on card to the system. See Chapter 5 for 3.
details on installing a PCI add-on card.
Make sure all power and data cables are properly connected and not blocking 4.
the airfl ow. See Chapter 5 for details on cable connections. Also, check that
the air shroud is properly installed.