Supero SuperServer 5016T-MR-LN4B, User Manual

Page: 54 / 104

5-18
S
UPER
S
ERVER 5016T-MRB/5016T-MR-LN4B User's Manual
Universal Serial Bus (USB)
There are two Universal Serial Bus
ports located on the I/O panel. An
additional six USB headers are in-
cluded on the board, which may be
used for front side access (cables not
included). USB 6 and USB 7 are "Type
A" connectors. See the table on the
right for pin defi nitions.
Universal Serial Bus
Pin Defi nitions (USB)
USB0/1
Pin # Defi nition
USB4/5/6/7
Pin # Defi nition
1 +5V 1 +5V
2 PO- 2 PO-
3 PO+ 3 PO+
4 Ground 4 Ground
5 N/A 5 Key
SGPIO Headers
The SGPIO (Serial General Purpose
Input/Output) headers are used to
communicate with an enclosure man-
agement chip on the backplane. The
T-SGPIO headers are for SATA and
the 3-SGPIO headers (X8STi only) are
for SAS confi gurations. See the table
on the right for pin defi nitions.
SGPIO Header Pin Defi nitions (T-SGPIO-0/
T-SGPIO-1, 3-TGPIO-0/3-SGPIO-1)
Pin# Defi nition Pin Defi nition
1 NC 2 NC
3 Ground 4 DATA Out
5 Load 6 Ground
7 Clock 8 NC
NC = No Connection
Power Supply SMBus Header
A Power SMB header is located at
SMB_PS1. Connect the appropriate
cable here to utilize SMB on your
system. See the table on the right for
pin defi nitions.
Power Supply SMB
Header Pin Defi nitions
(SMB_PS1)
Pin# Defi nition
1 Clock
2 Data
3 PWR Fail
4 Ground
5 +3.3V
LAN1/2 (Ethernet Ports)
The Ethernet ports (LAN1 and LAN2,
plus LAN3 and LAN4 on the X8STi-
LN4) are located beside the VGA port
on the I/O backplane. These ports
accept RJ45 type cables.