Supero SuperServer 5016T-MR-LN4B, User Manual

Page: 53 / 104

Chapter 5: Advanced Serverboard Setup
5-17
Wake-On-LAN
The Wake-On-LAN header is desig-
nated JWOL on the serverboard. See
the table on the right for pin defi ni-
tions. You must also have a LAN card
with a Wake-On-LAN connector and
cable to use this feature.
Chassis Intrusion
The Chassis Intrusion header is des-
ignated JL1. Attach an appropriate
cable from the chassis to inform you
of a chassis intrusion when the chas-
sis is opened
Chassis Intrusion
Pin Defi nitions (JL1)
Pin# Defi nition
1 Intrusion Input
2 Ground
Wake-On-LAN
Pin Defi nitions
(JWOL)
Pin# Defi nition
1 +5V Standby
2 Ground
3 Wake-up
External Speaker/Internal Buzzer
On the JD1 header, pins 1-4 are for
an external speaker and pins 3-4 are
for the internal speaker. If you wish to
use an external speaker, connect it
to pins 1-4 to. If you wish to use the
onboard speaker, you should close
pins 3-4 with a jumper.
Speaker Connector
(JD1)
Pin Setting Defi nition
Pins 3-4 Internal Speaker
Pins 1-4 External Speaker
Overheat/Fan Fail LED
The JOH can be connected to an
LED to provide warning of chassis
overheat. This LED will also blink to
indicate a fan failure. Refer to the table
on the right for pin defi nitions.
Overheat LED
Pin Defi nitions (JOH)
Pin# Defi nition
1 5vDC
2 OH Active
OH/Fan Fail LED
Status Indications
State Indication
Solid Overheat
Blinking Fan Fail
Onboard Power LED
An onboard Power LED header is
located at JLED. This header con-
nects to the control panel header
(JF1) to indicate the status of system
power. See the table on the right for
pin defi nitions.
Onboard PWR LED
Pin Defi nitions (JLED)
Pin# Defi nition
1 VCC
2 No Connection
3 Connection to PWR
LED in JF1