Supero SuperServer 5013C-M, User Manual

Page: 64 / 96

6-6
S
UPER
S
ERVER 5013C-M User's Manual
6-5 Power Supply
The SuperServer 5013C-M has a single 260 watt power supply. This power
supply has the capability of operating at 100 or 240 input volts. Depress the main
power button on the front of the chassis and then unplug the AC power cord to
completely remove power from the system before removing the power supply.
Power Supply Failure
If the power supply unit fails, the system will shut down and you will need to
replace the power supply unit. Replacement units can be ordered directly from
Supermicro (PWS-0055 - see contact infomation in Chapter 1).
Replacing the Power Supply
1. Accessing the inside of the SuperServer 5013C-M
To replace a power supply, you must first remove the top chassis cover.
To do so, first release the retention screws that secure the unit to the
rack. Grasp the two handles on either side and pull the unit straight out
until it locks (you will hear a "click"). Next, depress the two buttons on
the top of the chassis to release the top cover and push it away from
you. You can then lift the top cover from the chassis to gain full access
to the inside of the server.
2. Removing the power supply
First unplug the power cord from the system. To remove the failed
power unit, remove the two screws on the back of the power supply and a
third from the front of the power supply, which secures it to the bottom of the
chassis. You can then lift the unit straight out of the chassis. (The power
cord should have already been removed.)
3. Installing a new power supply
Replace the failed unit with another unit of the same wattage. It is highly
recommended to replace it with the exact same power supply. Carefully
insert the new unit into position in the chassis and secure it with the two
screws at the rear of the unit and the third at the front. Then reconnect the
power cord, replace the chassis top cover and push the unit back into the
rack. Finish by turning the power switch on the power supply on, and then
depress the power button on the front of the system.