Supero SuperServer 5013C-M, User Manual

Page: 62 / 96

6-4
S
UPER
S
ERVER 5013C-M User's Manual
6-4 Drive Bay Installation/Removal
Accessing the Drive Bays
CD-ROM/IDE/Floppy Disk Drives: For installing or removing the CD-ROM, IDE
or floppy disk drives, you will need to gain access to the inside of the
5013C-M by removing the top cover of the chassis.
Note: Only a "slim" CD-ROM drive and a "slim" floppy drive will fit in the
5013C-M.
IDE Drive Installation
The IDE drive is located at the front and inside of the chassis. The IDE drive is
not hot-swappable, meaning system power must be turned off before installing
or removing.
To install or remove the drive, first power down the system and then remove
the top cover of the chassis. Unscrew the retention screw at the top center
of the drive, then push the drive tray out from the back until you can grasp and
pull it out through the front of the chassis. Remove the drive from the drive
tray.
To add a new IDE drive, install a drive into the tray with the printed circuit
board side facing down and so that the mounting holes align with those in the
tray. Secure the drive to the tray with the four screws. Replace the top cover
when finished. See Figure 6-4.