Supero SUPERSERVER 1026T-UF, User Manual

Page: 94 / 118

7-8
S
UPER
S
ERVER 1026T-URF/1026T-UF User's Manual
QPI Links Speed
This feature selects QPI's data transfer speed. The options are Slow-mode, and
Full Speed .
QPI Frequency
This selects the desired QPI frequency. The options are Auto , 4.800 GT,
5.866GT, 6.400 GT.
QPI L0s and L1
This enables the QPI power state to low power. L0s and L1 are automatically
selected by the serverboard. The options are Disabled and Enabled.
Memory Frequency
This feature forces a DDR3 frequency slower than what the system has detected.
The available options are Auto , Force DDR-800, Force DDR-1066, and Force
DDR-1333.
Memory Mode
The options are Independent , Channel Mirror, Lockstep and Sparing.
Independent - All DIMMs are available to the operating system.
Channel Mirror - The serverboard maintains two identical copies of all data in
memory for redundancy.
Lockstep - The serverboard uses two areas of memory to run the same set of
operations in parallel.
Sparing - A preset threshold of correctable errors is used to trigger fail-over.
The spare memory is put online and used as active memory in place of the
failed memory.
Demand Scrubbing
A memory error-correction scheme where the Processor writes corrected data
back into the memory block from where it was read by the Processor. The op-
tions are Enabled and Disabled.
Patrol Scrubbing
A memory error-correction scheme that works in the background looking for and
correcting resident errors. The options are Enabled and Disabled.
Throttling - Closed Loop/Throttling - Open Loop
Throttling improves reliability and reduces power in the processor by automatic
voltage control during processor idle states. Available options are Disabled and
Enabled. If Enabled, the following items will appear: