Supero Supero SUPERSERVER 5018A-MLTN4, User Manual

Page: 68 / 120

5-18
SUPERSERVER 5018A-MLTN4 User's Manual
VGA Enable/Disable
JPG1 allows you to enable or disable
the VGA port. The default position is on
pins 1 and 2 to enable VGA. See the
table on the right for jumper settings.
VGA Enable/Disable
Jumper Settings
Jumper Setting Definition
Pins 1-2 Enabled
Pins 2-3 Disabled
Watch Dog
JWD1 enables the Watch Dog func-
tion, a system monitor that takes action
when a software application freezes
the system. Jumping pins 1-2 will have
WD reboot the system if a program
freezes. Jumping pins 2-3 will gener-
ate a non-maskable interrupt for the
program that has frozen. See the table
on the right for jumper settings. Watch
Dog must also be enabled in BIOS.
Note:
when Watch Dog is enabled, the user
must write their own application software to
disable the Watch Dog Timer.
Watch Dog
Jumper Settings
Jumper Setting Definition
Pins 1-2 Reset
Pins 2-3 NMI
Open Disabled
BMC Enable
Jumper JPB1 allows you to enable the
embedded BMC (Baseboard Manage-
ment Controller) to provide IPMI 2.0
support. See the table on the right for
jumper settings. The default setting is
enabled.
BMC Enable
Jumper Settings
Jumper Setting Definition
Pins 1-2 BMC Enabled
Pins 2-3 Disabled
PCI Slot_SMB Enable
Jumper Settings
Jumper Setting Definition
Closed Enabled
Open (Default) Disabled
PCI-E Slot SMB Enable
Use jumpers I
2
C1/I
2
C2 to enable PCI
SMB (System Management Bus) sup-
port to improve system management
for the onboard PCI-E slots. The de-
fault setting is disabled. See the table
on the right for jumper settings.