Supero SC823, User Manual

Page: 42 / 74

SC823 Chassis Manual
5-4
Figure 5-4. Installing a Hard Drive into the Drive Tray
Installing a Hard Drive to the Drive Tray
1. Remove the two screws (A) securing the dummy drive (B) to the hard drive
tray (C).
2. Remove the dummy drive from the hard drive tray.
Caution : Except for short periods of time while swapping hard drives, do not operate
the server with the hard drive bays empty.
3. Place the hard drive tray on a flat, stable surface such as a desk, table, or
work bench.
4. Slide the hard drive (D) into the tray with the printed circuit board side facing
downward.
5. Carefully align the mounting holes in the hard drive and the tray. Make sure
the bottom of the hard drive and bottom of the hard drive tray are flush.
6. Secure the hard drive using all four of the screws provided (E).
7. Slide the drive tray into the hard drive bay of the chassis.
8. Close the drive carrier by gently pushing the the drive tray handle back into
the closed position.
Note : Only enterprise level hard drives are recommended for use in Supermicro
chassis.
1
A
1
A
1
C
1
B
1
D
1
E
1
E