Supero H8SCM, User Manual

Page: 28 / 82

H8SCM(-F) SERVERBOARD USER'S MANUAL
2-8
Memory Support
T h e H 8 S C M ( - F ) s e r v e r b o a r d s u p p o r t s s i n g l e a n d d u a l c h a n n e l ,
DDR3-1600/1333/1066 Mhz speed registered ECC/Unbuffered ECC/non-ECC
SDRAM. Only interleaved memory is supported, so you must populate two DIMM
slots at a time, one per channel (see procedure above).
Populating two adjacent slots at a time with memory modules of the same size and
type will result in interleaved (128-bit) memory, which is faster than non-interleaved
(64-bit) memory.
Maximum Memory
The H8SCM(-F) serverboard supports up to 32 GB of ECC/Non-ECC UDIMM or up
to 128 GB of ECC RDIMM in four (4) DIMM slots.
Memory Population for Optimal Performance
# DIMMS Channel 1 Channel 2
2 DIMMs DIMM1A DIMM2A
4 DIMMs DIMM1A DIMM1B DIMM2A DIMM2B
Note: Memory speed support is dependent on the type of CPU used on the board.
Figure 2-1. Installing DIMM into Slot
To I n s t a l l : I n s e r t
module vertically and
press down until it
s n a p s i n t o p l a c e .
Pay attention to the
alignment notch at
the bottom.
To R e m o v e : U s e
your thumbs to gently
push the release tabs
near both ends of the
module. This should
release it from the
slot.
Top View of DDR3 Slot
Release Tab Release Tab
Note: Notch should align with
the receptive key point on
the slot.
Notch Notch
Front View