Supero H8QGL-6F, User Manual

Page: 71 / 86

Chapter 4: BIOS
4-11
Redirection After BIOS POST
This sets redirection after the BIOS POST for your system.
Options are Disabled (no redirection after BIOS POST), Boot Loader (redirection
during POST and during boot loader) and Always (redirection always active).
Note that some OS's may not work with this set to Always.
Terminal Type
Selects the type of the target terminal. Options are ANSI , VT100 and
VT-UTF8.
VT-UTF8 Combo Key Support
Allows you to enable or disable VT-UTF8 combination key support for ANSI/
VT100 terminals. Options are Enabled or Disabled.
Sredir Memory Display Delay
Use this setting to set the delay in seconds to display memory information.
Options are No Delay , 1 sec, 2 secs and 4 secs.


Hardware Health Confi guration
CPU Overheat Temperature
This setting allows you to specify the type of alarm for CPU overheating. Options
include The Early Alarm and The Default Alarm .
Other items in the submenu are systems monitor displays for the following
information:
CPU1 Temperature, CPU2 Temperature, CPU3 Temperature, CPU4
Temperature, System Temperature, CPU1 VCore, CPU2 VCore, CPU3 VCore,
CPU4 VCore, CPU1~4 DIMM Voltage, Chipset SR56x0 Voltage, + 5V, +12V,
3.3V Vcc (V), 3.3V standby (Vsb) and Battery Voltage (Vbat).
CPU Temperature Display (CTD)
CPU Temperature descriptions are defi ned as:
Low

[Tctl Value = Lowest Value, Tctl Value = -45]
Medium

[Tctl Value = -46, Tctl Value = 60]
High

[Tctl Value = -61 and Above]
Note: Only CPU temperature (Low, Medium, High) and system temperature (RT1)
are required to be displayed in BIOS and in-system monitoring software. Other