Chapter 2: Installation
2-19
SCSI Termination Enable/
Disable (H8DM8-2 only)
Jumpers JPA2 and JPA3 are used to
enable or disable termination for the
SCSI Channel A and B connector, re-
spectively. The default setting is open
to enable termination. See the table on
right for jumper settings.
Note:
In order for the SCSI drives to
function properly, please do not change
the default setting (enabled) set by the
manufacturer.)
SCSI Term. Enable/Disable
Jumper Settings (JPA2, JPA3)
Jumper Setting Defi nition
Open
Enabled
Closed
Disabled
Compact Flash Master/Slave
The JCF1 jumper allows you to assign
either master or slave status a compact
fl ash card installed in IDE1. See the
table on the right for jumper settings.
Compact Flash
Master/Slave
Jumper Settings (JCF1)
Jumper Setting Defi nition
Closed
Master
Open
Slave
VGA Enable/Disable
JPG1 allows you to enable or disable
the VGA port. The default position
is on pins 1 and 2 to enable VGA.
See the table on the right for jumper
settings.
VGA Enable/Disable
Jumper Settings (JPG1)
Jumper Setting Defi nition
Pins 1-2
Enabled
Pins 2-3
Disabled
SIMLC (IPMI Slot)
The SIMLC slot on the H8QM3-2 and
H8QMi-2 is reserved for an optional
IPMI card.
Note:
with an IPMI card installed in
the SIMLC slot, the PCI-X slot #1 can-
not be populated due to mechanical
concerns.
