SC503 Chassis Manual
5-6
Add-on Card/Expansion Slot Setup
SC503 chassis includes an I/O slot for the optional add-on card. A full-height, half-
length PCI add-on card is supported. A riser card is required in order to adapt the
add-on card to the 1U chassis. For additional information on add-on cards and
risers cards, refer to the Supermicro website at www.supermicro.com
Figure 5-5: Installing the Add-on Card
Disconnect the chassis from the power source.
1.
Remove the screws holding the add-on card clip and the dummy bracket
2.
which covers the openings in the back of the chassis.
Remove the add-on card clip and the dummy plate from the chassis.
3.
Outside of the chassis, insert the add-on card into the riser card.
4.
Insert the assembled add-on card and riser card into the expansion slot inside
5.
the chassis, carefully aligning the plate of the add-on card with the openings
in the back of the chassis.
Replace the add-on card clip and screw it onto the chassis to hold the add-on
6.
card in place.
Replace the chassis cover.
7.
Add-on Card
Bracket Clip
Bracket
